login未遂事件

MIPS SMP OpenBSD sgi sgi octane

残念です(´・ω・`)…

>> bootp():
Setting $netaddr to 192.168.3.2 (from server )
Obtaining  from server 
5175104+561280 entry: 0xa800000020020000
ARCS64 Firmware Version 64.0
Found SGI-IP30, setting up.
Initial setup done, switching console.
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2009 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 4.6-current (GENERIC-IP30.MP) #50: Tue Dec  8 16:44:30 JST 2009
    syuu@kikurage.nk3f.data-hotel.intranet:/usr/src/sys/arch/sgi/compile/GENERIC-IP30.MP
real mem = 1073741824 (1024MB)
rsvd mem = 1064960 (1MB)
avail mem = 1018605568 (971MB)
mainbus0 at root: Octane
cpu0 at mainbus0: MIPS R12000 CPU rev 3.5 400 MHz, R10000 FPU rev 0.0
cpu0: cache L1-I 32KB D 32KB 2 way, L2 2048KB 2 way
cpu1 at mainbus0: Unknown CPU type (0x0) rev 0.0 0 MHz, Software FP emulation rev 0.0
cpu1: cache L1-I 32KB D 32KB 2 way, L2 2048KB direct
clock0 at mainbus0: ticker on int5 using count register
xbow0 at mainbus0: XBow revision 5
xheart0 at xbow0 widget 8: Heart revision 6
onewire0 at xheart0
owserial0 at onewire0 "16kb EPROM" sn 0000004d74fa
owserial0: "PM20400MHZ" p/n 030-1476-001, serial KWL381
xbridge0 at xbow0 widget 15: Bridge revision 4
xbpci0 at xbridge0 bus 0: 33 MHz PCI bus
pci0 at xbpci0 bus 0
isp0 at pci0 dev 0 function 0 "QLogic ISP1020" rev 0x05: irq 0, xbow irq 15
isp0: Board Type 1040B, Chip Revision 0x5, loaded F/W Revision 4.66.0
scsibus0 at isp0: 16 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <SEAGATE, ST336704LSUN36G, 032C> SCSI3 0/direct fixed
sd0: 34732MB, 512 bytes/sec, 71132959 sec total
isp1 at pci0 dev 1 function 0 "QLogic ISP1020" rev 0x05: irq 1, xbow irq 14
isp1: Board Type 1040B, Chip Revision 0x5, loaded F/W Revision 4.66.0
scsibus1 at isp1: 16 targets, initiator 0
ioc0 at pci0 dev 2 function 0 "SGI IOC3" rev 0x01
onewire1 at ioc0
owmac0 at onewire1 "1kb EPROM" sn 000002d29696
owmac0: Ethernet Address 08:00:69:13:67:82
owserial1 at onewire1 "16kb EPROM" sn 0000004d4ee4
owserial1: "FP1" p/n 030-0891-003, serial LMR447
owserial2 at onewire1 "16kb EPROM" sn 0000004e12fb
owserial2: "PWR.SPPLY.ER" p/n 060-0035-002, serial AAE0420107
ioc0: ethernet irq 2, xbow irq 13
ioc0: superio irq 4, xbow irq 12
com0 at ioc0 base 0x20178: ns16550a, 16 byte fifo
com0: console
com1 at ioc0 base 0x20170: ns16550a, 16 byte fifo
iockbc0 at ioc0
iec0 at ioc0: 128KB SSRAM, address 08:00:69:13:67:82
icsphy0 at iec0 phy 1: ICS1890 10/100 PHY, rev. 3
lpt at ioc0 not configured
dsrtc0 at ioc0: DS1687
"SGI Rad1" rev 0xc0 at pci0 dev 3 function 0 not configured
"Odyssey" revision 2 at xbow0 widget 11 not configured
power0 at mainbus0
/dev/ksyms: Symbol table not valid.
vscsi0 at root
scsibus2 at vscsi0: 256 targets
softraid0 at root
boot device: sd0
root on sd0a swap on sd0b dump on sd0b
Automatic boot in progress: starting file system checks.
/dev/rsd0a: file system is clean; not checking
/dev/rsd0k: 1 files, 1 used, 8137982 free (14 frags, 1017246 blocks, 0.0% fragmentation)
/dev/rsd0k: MARKING FILE SYSTEM CLEAN
/dev/rsd0d: INCORRECT BLOCK COUNT I=3 (4 should be 0) (CORRECTED)
/dev/rsd0d: UNREF FILE I=3  OWNER=root MODE=100600
/dev/rsd0d: SIZE=0 MTIME=Jun  2 07:09 2009  (CLEARED)
/dev/rsd0d: 1 files, 1 used, 1182050 free (18 frags, 147754 blocks, 0.0% fragmentation)
/dev/rsd0d: MARKING FILE SYSTEM CLEAN
/dev/rsd0f: 13459 files, 239880 used, 790647 free (223 frags, 98803 blocks, 0.0% fragmentation)
/dev/rsd0f: MARKING FILE SYSTEM CLEAN
/dev/rsd0g: 1 files, 1 used, 514438 free (14 frags, 64303 blocks, 0.0% fragmentation)
/dev/rsd0g: MARKING FILE SYSTEM CLEAN
/dev/rsd0h: 105 files, 105 used, 1733269 free (77 frags, 216649 blocks, 0.0% fragmentation)
/dev/rsd0h: MARKING FILE SYSTEM CLEAN
/dev/rsd0j: 1 files, 1 used, 935490 free (18 frags, 116934 blocks, 0.0% fragmentation)
/dev/rsd0j: MARKING FILE SYSTEM CLEAN
/dev/rsd0i: 1 files, 1 used, 935490 free (18 frags, 116934 blocks, 0.0% fragmentation)
/dev/rsd0i: MARKING FILE SYSTEM CLEAN
/dev/rsd0e: INCORRECT BLOCK COUNT I=129927 (1344 should be 416) (CORRECTED)
/dev/rsd0e: INCORRECT BLOCK COUNT I=129929 (416 should be 0) (CORRECTED)
/dev/rsd0e: LINK COUNT FILE I=103942  OWNER=root MODE=100444
/dev/rsd0e: SIZE=3339 MTIME=Jun  2 07:09 2009  COUNT 2 SHOULD BE 1 (ADJUSTED)
/dev/rsd0e: LINK COUNT FILE I=129927  OWNER=root MODE=100644
/dev/rsd0e: SIZE=663552 MTIME=Jun  2 07:09 2009  COUNT 2 SHOULD BE 1 (ADJUSTED)
/dev/rsd0e: UNREF FILE I=129929  OWNER=root MODE=100644
/dev/rsd0e: SIZE=0 MTIME=Jun  2 07:09 2009  (CLEARED)
/dev/rsd0e: FREE BLK COUNT(S) WRONG IN SUPERBLK (SALVAGED)
/dev/rsd0e: SUMMARY INFORMATION BAD (SALVAGED)
/dev/rsd0e: BLK(S) MISSING IN BIT MAPS (SALVAGED)
/dev/rsd0e: 496 files, 2740 used, 1860038 free (102 frags, 232492 blocks, 0.0% fragmentation)
/dev/rsd0e: MARKING FILE SYSTEM CLEAN
setting tty flags
pfctl: DIOCADDRULE: Operation not supported by device
pf enabled
starting network
Corrupt lease file - possible data loss!
DHCPDISCOVER on iec0 to 255.255.255.255 port 67 interval 2
DHCPOFFER from 10.243.40.98 (00:c0:9f:3c:e4:e2)
DHCPOFFER from 10.243.40.253 (00:25:46:93:26:c8)
DHCPREQUEST on iec0 to 255.255.255.255 port 67
DHCPACK from 10.243.40.98 (00:c0:9f:3c:e4:e2)
bound to 192.168.3.2 -- renewal in 0 seconds.
pfctl: DIOCADDRULE: Operation not supported by device
starting system logger
starting initial daemons:.
__mp_lock_spin:0xa80000002055c830 locker:0xa8000000202e5c98 cur:0xa8000000202e5c98 sr:140097a0 ipl:2 imr:420000000000
__mp_lock_spin:0xa80000002055c830 locker:0xa8000000202e5c98 cur:0xa8000000202e5c98 sr:140097a0 ipl:2 imr:420000000000
__mp_lock_spin:0xa80000002055c830 locker:0xa8000000202e5c98 cur:0xa8000000202e5c98 sr:140097a0 ipl:2 imr:420000000000

ここまで来てデッドロック。