【一発】SGI Origin 350の起動時にエラーが出る件、治ったよ。【解決】

http://nekochan.net/の人達や@shigefumiさん達にIO9やメモリ、CPUとかを一度抜いて挿し直してみろ！と言われたので、試しにやってみた。

これ、IO9ボード。SCSIとATAとイーサーネットコントローラが乗ってるっぽい。
一度抜いて挿し直してみる。

あっさり治った。

entering console mode  001c03 CPU0, <CTRL_T> to escape to L1

Base I/O Ethernet set to /dev/ethernet/tg0
Probing IOC4 ATA adapter 2
IOC4 RevId = 83
Detected Vendor id/Product MATSHITA DVD-ROM SR-8178

Walking SCSI Adapter 0, (pci id 3)
1+ Device Vendor Product: SGI ST3146707LC
2+ Device Vendor Product: SGI ST3146707LC
3- 4- 5- 6- 7- 8- 9- 10- 11- 12- 13- 14- 15- = 2 device(s)

Walking SCSI Adapter 1, (pci id 3)
1- 2- 3- 4- 5- 6- 7- 8- 9- 10- 11- 12- 13- 14- 15- = 0 device(s)

Initializing PROM Device drivers ..........             
  Initializing Base I/O Ethernet Interface...Failed.  MII Status Register = 0x7949
Done.

  ---------------Interface Configuration Summary----------------
  ASIC|Revision|MAC Address       : 5701|B5|08:00:69:11:e6:48
  Link Negotiation|Advertisement  : On|<H10 F10 H100 F100 F1000>
  Link|Speed|Duplex|Rx/Tx FlowCtrl: Down|10|Half|Off/Off
  --------------------------------------------------------------

DONE

Checking hardware inventory ...............              /hw/rack/001/bay/03: PCI DEV 1 missing
/hw/rack/001/bay/03: PCI DEV 2 missing

DONE


**** System Configuration and Diagnostics Summary ****

CONFIG:
         No. of NODEs enabled    = 1
         No. of NODEs disabled   = 0
         No. of CPUs enabled     = 2
         No. of CPUs disabled    = 0
         Mem enabled             = 2048 MB
         Mem disabled            = 0 MB
         No. of RTRs enabled     = 0
         No. of RTRs disabled    = 0


DIAG RESULTS:
         ALL DIAGS PASSED.

**** End System Configuration and Diagnostics Summary ****


System Maintenance Menu

1) Start System
2) Install System Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor

Option?